Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Capacity and distribution

Cargo capacity depends on the total weight of the occupants.

(Cargo capacity) = (Total load capacity) - (Total weight of occupants)

Steps for Determining Correct Load Limit

  1. Locate the statement “The combined weight of occupants and cargo should never exceed XXX kg or XXX lbs.� on your vehicle’s placard.
  2. Determine the combined weight of the driver and passengers that will be riding in your vehicle.
  3. Subtract the combined weight of the driver and passengers from XXX kg or XXX lbs.
  4. The resulting figure equals the available amount of cargo and luggage load capacity.

    For example, if the “XXXâ€� amount equals 1400 lbs. and there will be five 150 lb passengers in your vehicle, the amount of available cargo and luggage load capacity is 650 lbs. (1400 - 750 (5150) = 650 lbs.)

  5. Determine the combined weight of luggage and cargo being loaded on the vehicle. That weight may not safely exceed the available cargo and luggage load capacity calculated in Step 4.
  6. If your vehicle will be towing a trailer, load from your trailer will be transferred to your vehicle. Consult this manual to determine how this reduces the available cargo and luggage load capacity of your vehicle.
Cargo and luggage
Take notice of the following information about storage precautions, cargo capacity and load: ...

Calculation formula for your vehicle
Cargo capacity Total load capacity (vehicle capacity weight) When 2 people with the combined weight of A lb. (kg) are riding in your vehicle, which has a total load capacity (vehicle cap ...

Other materials:

How to proceed with troubleshooting
Hint: The ecm of this system is connected to the can and multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the can and multiplex communication systems The intelligent tester can be used at steps 3, 4, 6, and 9. ...

Removal
1. REMOVE FRONT WHEELS 2. REMOVE FRONT STABILIZER LINK ASSEMBLY LH (a) Remove the 2 nuts and front stabilizer link assembly LH. HINT: If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud. 3. REMOVE FRONT STABILIZER LINK ASSEMBLY RH HINT: Remove the ...

Parts location
HOW TO PROCEED WITH TROUBLESHOOTING 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS (a) Confirm problem symptoms. 3 CHECK AND CLEAR DTCS 4 PROBLEM SYMPTOM CONFIRMATION 5 SYMPTOM SIMULATION 6 DTC CHECK (OTHER THAN MULTIPLEX DTC) 7 DTC CHART 8 PROBLEM SYMP ...

© 2011-2026 Copyright www.tsienna.net