Toyota Sienna Service Manual: CD Changer Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal
DTC 63-10 CD Changer Mechanical Error
DTC 63-11 CD Insertion and Ejection Error
DTC 63-12 CD Reading Abnormal
DESCRIPTION
|
DTC No. |
DTC Detection Condition |
Trouble Area |
| 63-10 | A mechanical error in the CD changer is detected while the CD is not being inserted or ejected. | Radio and navigation assembly |
| 63-11 | CD insertion or ejection is failed | |
| 63-12 | CD read problem occurs. |
INSPECTION PROCEDURE
HINT: After the inspection is completed, clear the DTCs
1 REPLACE RADIO AND NAVIGATION ASSEMBLY
END
Camera Picture Error
DTC 5C-40 Camera Picture Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from the camera cannot be
transmitted.
...
Wrong Disc/ Disc cannot be Read
DTC 63-41 Wrong Disc
DTC 63-42 Disc cannot be Read
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
63-41
An unsuitable disc is inserted
CD
...
Other materials:
How to proceed with
troubleshooting
The intelligent tester can be used in steps 4, 6, 8 and 9.
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
3 PASSENGER AIRBAG ON/OFF INDICATOR CHECK
4 DTCs CHECK (Present and Past DTCs)
Check for DTCs.
Result
GO TO PROBLEM SYMPTOMS TABLE
5 DTCs CHART
6 CIRCUIT ...
Diagnosis system
DESCRIPTION
(a) When troubleshooting OBD II (On-Board
Diagnostics) vehicles, an intelligent tester
(complying with SAE J1987) must be connected to
the DLC3 (Data Link Connector 3) of the vehicle.
Various data in the vehicle's ECM (Engine Control
Module) can be then read.
(b) OBD II regu ...
DTC check / clear
1. CHECK DTC
Connect the intelligent tester to the DLC3.
Connect the intelligent tester to the Controller
Area Network Vehicle Interface Module (CAN
VIM). Then connect the CAN VIM to the Data
Link Connector 3 (DLC3).
Turn the ignition switch to the ON posi ...
