Toyota Sienna Service Manual: Cellular Phone cannot Send / Receive
INSPECTION PROCEDURE
1 CHECK BLUETOOTH SETTINGS
- Check if the Bluetooth settings are correct.
OK: Bluetooth settings are correct.
2 CHECK CELLULAR PHONE
- Check if the cellular phone is Bluetooth compatible.
HINT: Some versions of Bluetooth compatible cellular phones may not function.
OK: Phone is Bluetooth compatible.
3 CHECK SETTINGS
- Check if the cellular phone functions.
HINT: The cellular phone is unable to call under any of the following conditions.
- The cellular phone is locked.
- The directory is being transferred.
- The line is crossed.
- Transmission is regulated.
- The power is off.
- The cellular phone is not connected to Bluetooth ("BT" is displayed while connected).
OK: None of the above conditions exist
4 CHECK CELLULAR PHONE
- Check if the cellular phone can make a call.
HINT: When the battery is low, calls cannot be made or received.
OK: Cellular phone can make a call.
5 CHECK RECEPTION
- Set the cellular phone so that it can receive calls.
- Place the cellular phone close to the radio and navigation assembly.
- Check if the cellular phone has reception according to the radio and navigation assembly.
OK: Cellular phone has reception.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Cellular Phone Registration Failure, Phone Directory Transfer Failure
INSPECTION PROCEDURE
1 CHECK CURRENT CONDITIONS
Proceed to the next step according to the table below.
RESULT
2 CHECK USING ANOTHER CELLULAR PHONE
Check if the system functions using an ...
Cannot Call in a Certain Place
INSPECTION PROCEDURE
1 CHECK SURROUNDING CONDITIONS
Check if the cellular phone can make calls in a certain
place.
OK:
It can make calls
2 CHECK RECEPTION
Enter the "Informati ...
Other materials:
Precaution
1. Before operating the power rear no. 2 seat with
stowing function, make sure that there is nothing in
the path of the seat.
CAUTION:
If someone or something is caught between the seat
and other parts, injury or damage may result.
If the system detects that the folding motor is locke ...
Inspection
1. INSPECT FRONT STABILIZER LINK ASSEMBLY LH
(a) As shown in the illustration, flip the ball joint stud
back and forth 5 times, before installing the nut.
(b) Using a torque wrench, turn the nut continuously at
a rate of 2 to 4 seconds per 1 turn and take the
torque reading on the 5th turn.
...
Precaution
NOTICE:
Perform the RESET MEMORY (AT initialization) when
replacing the automatic transaxle assembly, engine
assembly or ECM (See page AX-16).
Perform the REGISTRATION (VIN registration) when
replacing the ECM (See page ES-15).
HINT:
RESET MEMORY can not be ...
