Toyota Sienna Service Manual: Charge Warning Light Comes ON while Driving
INSPECTION PROCEDURE
1 CHECK LOCK FUNCTION OF CLUTCH PULLEY
(a) Check the lock function with the pulley installed in the vehicle.
(1) Visually check that the rotor in the generator operates with the engine started.
(b) Check the lock function with the pulley removed from the vehicle.
(1) Remove the generator pulley cap. Using SST, hold the generator rotor.
(2) Turn the clutch pulley clockwise and check that the outer ring locks.
OK: The outer ring locks.
SST 09820-63020
2 CHECK LOCK OF CLUTCH PULLEY
(a) Start the engine and visually check for looseness of the clutch pulley.
OK: The clutch pulley is not loose.
REPLACE GENERATOR ASSEMBLY
On-vehicle inspection
1. Check battery electrolyte level
(a) Check the electrolyte level.
(1) If the electrolyte level is low, replace the battery
(or add distilled water) and check the charging
system.
2. CHECK BAT ...
Noise Occurs from Generator while Engine is Running
INSPECTION PROCEDURE
1 CHECK LOOSENESS OF V-RIBBED BELT
(a) Check the tension of the belt by pushing it down with a
finger.
OK:
The tension of the belt is enough.
2 CHECK V-RIBBED BELT FOR W ...
Other materials:
Suspension
SST
RECOMMENDED TOOLS
EQUIPMENT
TIRE AND WHEEL
RECOMMENDED TOOLS
EQUIPMENT
...
Eject Error/ Elevator Error/ Clamp Error/ Eject Error/ Elevator Error/ Clamp
Error
DTC 62-45 Eject Error
DTC 62-51 Elevator Error
DTC 62-52 Clamp Error
DTC 63-45 Eject Error
DTC 63-51 Elevator Error
DTC 63-52 Clamp Error
DESCRIPTION
DTC No.
DTC Detecting Condition
Trouble Area
62-45
Disc cannot be ejected.
Radio receiver
62-5 ...
CD cannot be Ejected
INSPECTION PROCEDURE
1 PRESS "EJECT" AND CHECK OPERATION
Press the CD EJECT switch of the radio receiver for 2
seconds or more and check that the CD is ejected.
OK:
CD is ejected
2 REPLACE CD WITH ANOTHER AND RECHECK
Insert another CD and check if it is ejected.
OK:
CD ...
