Toyota Sienna Service Manual: Circuit opening relay
Inspection
1. INSPECT CIRCUIT OPENING RELAY
- Using an ohmmeter, measure the resistance according to the value(s) in the table below.
Standard resistance
If the result is not as specified, replace the relay.
EFI relay
Inspection
1. INSPECT EFI RELAY
(a) Using an ohmmeter, measure the resistance
according to the value(s) in the table below.
Standard resistance
If the result is not as specified, replace ...
Air fuel ratio sensor relay
INSPECTION
1. INSPECT AIR FUEL RATIO SENSOR RELAY
Using an ohmmeter, measure the resistance
according to the value(s) in the table below.
Standard resistance
If the result is ...
Other materials:
Reassembly
1. INSTALL BRAKE MASTER LESS RESERVOIR TANK CYLINDER SUB-ASSEMBLY
(a) Apply lithium soap base glycol grease to the 2 brake
master cylinder union grommets and install them to
the brake master less reservoir tank cylinder subassembly.
(b) Using a pin punch (φ 5 mm) and hammer, install the
...
GCWR, TWR and Unbraked TWR
Confirm that the gross trailer weight, gross combination weight, gross
vehicle weight, gross axle weight and tongue weight are all within the
limits.
GCWR*
2WD models: 8900 lb. (4037 kg)
AWD models: 8990 lb. (4078 kg)
TWR*
3500 lb. (1588 kg)
Unbraked TWR*
1000 lb. (454 kg)
*: These models ...
MPX Body ECU Stop
DTC B1200 MPX Body ECU Stop
DESCRIPTION
This DTC is detected when communication between the multiplex network body
ECU and the multiplex
network gateway ECU stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1200
Body ECU comm ...
