Toyota Sienna Service Manual: Combination meter

Meter Illumination does not Dim at Night

DESCRIPTION  Confirm that the vehicle is equipped with the optitron meter, then check this circuit.  The combination meter assembly receives a auto dimmer signal from the body EC ...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working. 2. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY ...

Other materials:

If you have a flat tire (vehicles with run-flat tires)
Your vehicle is not equipped with a spare tire, but instead you can continue driving the vehicle with run-flat tires even if any tire goes flat. In this case, slow down and drive with extra caution. Run-flat tires (A “RFT” or “DSST” mark is molded on the sidewall) Take your vehicle to ...

Installation
1. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY (a) Install the power steering gear assembly with the 2 bolts and nuts. Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf) 2. CONNECT PRESSURE FEED TUBE ASSEMBLY (a) Connect the pressure feed tube assembly to the power steering gear asse ...

Installation
1. Install heated oxygen sensor (for bank 2 sensor 2) (see page ec-34) 2. Install front exhaust pipe assembly (a) Install 2 new gaskets to the front exhaust pipe assembly. (b) Install the front exhaust pipe assembly with the 4 nuts. Torque: 62 n*m (632 kgf*cm, 46 ft.*Lbf) 3. INSTALL CE ...