DTC P1616 Communication Error from ECM to Distance Control ECU
DTC U0100 Lost Communication with ECM/PCM "A"
DESCRIPTION
The ECM receives signals from each sensor and ECU, then sends signals such as A/T signals, cruise control operation signals, low speed operation signals, brake control operation signals, and laser light emission prohibiting signals, to the distance control ECU. The ECM is the only component that has a function to record and output the DTCs in the dynamic laser cruise control system. Therefore, if the distance control ECU detects a communication error from the ECM, it sends a malfunction signal back to the ECM.
DTC No. |
DTC Detection Condition |
Trouble Area |
P1616 |
While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a logical error signal from the distance control ECU for more than a specific amount of time, the ECM records this logical error code |
|
U0100 |
While the dynamic laser cruise control is either preparing for operation or operating, if the ECM continuously receives a communication cut off signal from the distance control ECU for more than a specific amount of time, the ECM records this communication cut off code |
|
INSPECTION PROCEDURE
HINT: This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.
1 CHECK CAN COMMUNICATION SYSTEM
Refer to HOW TO PROCEED WITH TROUBLESHOOTING
END
Installation
1. INSTALL VANE PUMP ASSEMBLY
(a) Temporarily install the bolt to the vane pump
assembly.
(b) Install the vane pump assembly.
(c) Temporarily install the bolt (B).
(d) Using SST, tighten the 2 bolts.
SST 09249-63010
Torque:Without SST
43 N*m (439 kgf*cm, 32 ft.*lbf)
With SST
29 ...
Air fuel ratio sensor relay
INSPECTION
1. INSPECT AIR FUEL RATIO SENSOR RELAY
Using an ohmmeter, measure the resistance
according to the value(s) in the table below.
Standard resistance
If the result is not as specified, replace the relay. ...
For vehicles equipped with vehicle stability control (vsc) system
(a) Notices when using drum tester
Notices when using drum tester.
(1) When using a drum tester, be sure to start the
engine with the ignition switch OFF, and connect
SST to the terminals TS and CG of the DLC3
before the measurement in order to cancel the
VSC operation.
SST 09843-18040
...