Toyota Sienna Service Manual: Communication Error from VSC to ECM
DTC P1630 Communication Error from VSC to ECM
DTC U0122 Lost Communication with Vehicle Dynamics Control Module
DESCRIPTION
The skid control ECU sends signals such as cruise control cancel demand signals and brake operation demand (from ECM) response signals to the ECM when the dynamic laser cruise control system is in operation.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|
P1630 |
While the dynamic laser cruise control is either preparing for operation or operating, if communication data from the skid control ECU is logically inconsistent for a certain amount of time, the ECM records this logical error code |
|
|
U0122 |
While dynamic laser cruise control is either preparing for operation or operating, if communication data from the skid control ECU is invalid for a certain amount of time, the ECM records this communication cut off code |
|
INSPECTION PROCEDURE
HINT: This circuit uses CAN communication. Therefore, if there are any malfunctions in the communication circuit, one or more DTCs in the CAN communication system are output.
1 CHECK CAN COMMUNICATION SYSTEM
Refer to HOW TO PROCEED WITH TROUBLESHOOTING
END
Distance Control ECU Malfunction
DTC P1617 Distance Control ECU Malfunction
DESCRIPTION
In the dynamic laser cruise control system, the ECM and the distance control
ECU communicate with one
another to control the system based on ...
Communication Error from ECM to VSC
DTC P1631 Communication Error from ECM to VSC
DTC U0100 Lost Communication with ECM/PCM "A"
DESCRIPTION
The ECM sends signals such as A/T information signals, dynamic laser cruise
contr ...
Other materials:
Reassembly
1. INSTALL FRONT DISC
(a) Aligning the matchmarks, install the front disc.
HINT:
Select the installation position where the disc has
the minimum runout.
2. INSPECT DISC RUNOUT
(a) Temporarily fasten the disc with the hub nuts.
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
(b) Using a ...
ABS Control System Malfunction
DTC 43 ABS Control System Malfunction
DESCRIPTION
This DTC is output when the VSC system detects a malfunction in the ABS
control system.
INSPECTION PROCEDURE
NOTICE:
When replacing the brake actuator assembly, perform zero point calibration
(See page BC-70).
1 CHECK ABS CONTROL SYSTEM
( ...
System Voltage
MONITOR DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is
off. This power allows the
ECM to store data such as DTC history, freeze frame data and fuel trim values.
If the battery voltage falls
below a minimum level, these memories are cleared and the ...
