Toyota Sienna Service Manual: Components

Toyota Sienna Service Manual / 2GR-FE Engine control system / Throttle body / Components

Components

On-vehicle inspection

1. INSPECT THROTTLE BODY Listen to the throttle control motor operating sounds. Turn the ignition switch to the ON position. When pressing the accelerator pedal position sens ...

Other materials:

Removal
1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE HINT: See page EM-26 2. REMOVE OIL LEVEL GAUGE GUIDE SUBASSEMBLY (See page EM-39) 3. REMOVE NO. 1 OIL PIPE (See page EM-77) 4. REMOVE OIL PIPE (See page EM-77) 5. REMOVE CRANKSHAFT PULLEY (See page EM-79) 6. SEPARATE OIL COOLER PIPE (a) Remove th ...

Installation
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY Check that the ignition switch is off. Check that the battery negative (-) terminal is disconnected. CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation. &n ...

Fail-safe chart
If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily. HINT: *1: The vehicle can be driven slowly when the accelerator pedal is depressed firmly and slowly. If the accelerator pedal is depressed quickly, the vehicle may ...