Toyota RAV4 manuals

Toyota Sienna Service Manual: Components

Components

Components

Components

Fuel injector
...

Removal
1. DISCHARGE FUEL SYSTEM PRESSURE HINT: See page FU-1. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE NO. 1 ENGINE UNDER COVER 4. DRAIN ENGINE COOLANT (See page CO-6) 5. REMOVE FR ...

Other materials:

SRS Warning Light does not Come ON
DESCRIPTION WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK BATTERY Measure the voltage of the battery. Standard voltage: 11 to 14 V 2 CHECK CONNECTORS Turn the ignition switch to the LOCK position.  Disconnect the negative (-) terminal cable from the battery, and wait for at le ...

Installation
1. INSTALL CRANKSHAFT POSITION SENSOR  Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.  Install the crankshaft position sensor with the bolt. Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)  Connect the crankshaft position sensor connector. ...

Precaution
1. TIRE PRESSURE WARNING SYSTEM PRECAUTION (a) When the tire pressure warning light comes on, immediately check the tire pressure of the tire and adjust it to the specified value. (The tire pressure warning light will come on after blinking for 1 minute if there is an open in the tire press ...

В© 2011-2026 Copyright www.tsienna.net