Toyota RAV4 manuals

Toyota Sienna Service Manual: Control Module Performance

DTC P0607 Control Module Performance

DESCRIPTION

The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standards, the ECM will illuminate the MIL and set a DTC immediately.

The ECM also monitors the cruise control cancel circuit. If this circuit malfunctions, the ECM will set a DTC immediately (MIL is not illuminated).

DESCRIPTION

NOTICE: First check for an exhaust gas leak around the HO2S if P0606 is present. An exhaust gas leak generates noise in the HO2S output. The ECM may interpret this as an HO2S transistor malfunction.

MONITOR STRATEGY

MONITOR STRATEGY

TYPICAL ENABLING CONDITIONS

TYPICAL ENABLING CONDITIONS

TYPICAL MALFUNCTION THRESHOLDS

TYPICAL MALFUNCTION THRESHOLDS

INSPECTION PROCEDURE

1 CHECK WHETHER DTC OUTPUT RECURS (IN ADDITION TO DTC P0607)

  1. Connect the intelligent tester to the DLC3.
  2.  Turn the ignition switch to the ON position.
  3.  Turn the tester on.
  4.  Clear the DTC.
  5.  Turn the ignition switch off.
  6.  Disconnect the battery negative terminal and wait for 1 minute.
  7.  Connect the battery negative terminal.
  8. Turn the ignition switch to the ON position.
  9.  Enter the following menus: DIAGNOSIS / ENHANCED II / DTC INFO / CURRENT CODES.
  10.  Read the DTCs.

Result

Result

REPLACE ECM

ECM / PCM Processor
DTC P0606 ECM / PCM Processor DESCRIPTION The ECM continuously monitors its internal processors (CPUs), A/F sensor transistors and heated oxygen sensor (HO2S) transistors. This self-check ensures ...

Starter Relay Circuit High
DTC P0617 Starter Relay Circuit High MONITOR DESCRIPTION While the engine is being cranked, the positive battery voltage is applied to terminal STA of the ECM. If the ECM detects the Starter Co ...

Other materials:

Manual Up / Down Function does not Operate on Rear LH Only
DESCRIPTION If the manual UP/DOWN function does not operate, the power window motor, the regulator switch or the wire harness may be malfunctioning. WIRING DIAGRAM INSPECTION PROCEDURE 1 CHECK WIRE HARNESS (POWER SOURCE) Disconnect the P38 regulator switch connector.  Turn ...

Reassembly
1. INSTALL PLANETARY GEAR (a) Apply grease to the planetary gears and pin parts of the planetary shaft. (b) Install the 3 planetary gears. 2. INSTALL STARTER ARMATURE ASSEMBLY (a) Apply grease to the plate washer and the armature shaft. (b) Install the starter armature to the star ...

Stuck in Deceleration Sensor
DESCRIPTION The yaw rate sensor and deceleration sensor signal is sent to the skid control ECU through the CAN communication system. When there is a malfunction in the communication, it will be detected by the diagnosis function. WIRING DIAGRAM INSPECTION PROCEDURE HINT: When ...

В© 2011-2024 Copyright www.tsienna.net