Toyota Sienna 2010-2026 Owners Manual: Correct use of the seat belts

Toyota Sienna 2010-2026 Owners Manual / For safety and security / For safe use / For safety drive / Correct use of the seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle. Use a child restraint system appropriate for the child until the child becomes large enough to properly wear the vehicle’s seat belt.

Adjusting the mirrors

Make sure that you can see backward clearly by adjusting the inside and outside rear view mirrors properly.

WARNING

Observe the following precautions.

Failure to do so may result in death or serious injury.

Do not adjust the position of the driver’s seat while driving.
Doing so could cause the driver to lose control of the vehicle.
Do not place a cushion between the driver or passenger and the seatback.
A cushion may prevent correct posture from being achieved, and reduce the effectiveness of the seat belt and head restraint.
Do not place anything under the front seats.
Objects placed under the front seats may become jammed in the seat tracks and stop the seat from locking in place. This may lead to an accident and the adjustment mechanism may also be damaged.
When driving over long distances, take regular breaks before you start to feel tired.
Also, if you feel tired or sleepy while driving, do not force yourself to continue driving and take a break immediately.

Correct driving posture

Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. Adjust the seat so that you can depress the pedals fully and so ...

Seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle. ...

Other materials:

Problem symptoms table
HINT: Proceed to the troubleshooting for each circuit in the table below. AIRBAG SYSTEM Symptom Suspected Area The SRS warning light goes off after the primary check, but then comes on. SRS Warning Light Remains ON When the ignition switch is turned to t ...

License plate light assembly
COMPONENTS REMOVAL 1. REMOVE BACK DOOR GARNISH CENTER 2. REMOVE BACK DOOR SIDE GARNISH LH 3. REMOVE BACK DOOR SIDE GARNISH RH 4. REMOVE BACK DOOR STRAP COVER 5. REMOVE BACK DOOR PULL STRAP 6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 7. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE 8. RE ...

Installation
1. INSTALL AIR CONDITIONING BLOWER ASSEMBLY (a) Install the air conditioning blower assembly with the 3 bolts. Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) NOTICE: Tighten the bolts in the order shown in the illustration to install the air conditioning blower assembly. 2. INSTALL AIR CONDITIO ...