Toyota Sienna Service Manual: Cruise control main switch
COMPONENTS
Removal
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE STEERING WHEEL COVER LOWER NO.2 (24)
3. REMOVE STEERING WHEEL COVER LOWER NO.3 (24)
4. REMOVE HORN BUTTON ASSEMBLY
5. REMOVE CRUISE CONTROL MAIN SWITCH
- Disconnect the connectors.
- Remove the 2 screws and cruise control main switch.
Installation
1. INSTALL HORN BUTTON ASSEMBLY
2. INSTALL STEERING WHEEL COVER LOWER NO.3 (25)
3. INSTALL STEERING WHEEL COVER LOWER NO.2 (25)
4. INSPECT SRS WARNING LIGHT
TC and CG Terminal Circuit
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the system to enter the
self-diagnostic mode. If a
malfunction is present, DTCs will be output.
HINT:
When a particular warning ligh ...
Other materials:
Initialization
HINT:
The seatback position is initialized at the factory before
shipment, so initialization is not normally required.
There is an initialization function for cases when
reinitialization is required.
Before performing initialization procedure and initialization
release step ...
Initialization
Items to initialize
The following items must be initialized for normal system operation
after such cases as the battery being reconnected, or maintenance
being performed on the vehicle.
Item
When to initialize
Power sliding door
(if equipped)
After reconnecting o ...
Checking the messages
Display the message inbox screen.
Select the desired message from the list.
Check that the message is displayed.
E-mails: Select “Mark
Unread” or “Mark Read” to
mark mail unread or read on
the message inbox screen.
This function is available when “Update Read Stat ...
