Toyota Sienna 2010-2024 Owners Manual: Cup holders
- Front
Press in and release the front cup holder.
- Console box type A (if equipped)
- Console box type B (if equipped)
Pull the lid down.
- Console box type C (if equipped)
- Second seat (if equipped)
Removing the second center seat.
- Rear
Cup holder light (console box type)
The cup holder light turns on when the headlight switch is on.
| WARNING
Do not place anything other than cups or beverage cans in the cup
holders.
Other items may be thrown out of the holders in the event of an accident or sudden braking and cause injury. If possible, cover hot drinks to prevent burns. |
Console box
Press the tab.
Type A
Type B
Sliding the console box (type B)
From front
Press the tab and slide the console box.
From rear
Pull up the lever and slide the c ...
Bottle holders
Front
Rear
When storing a bottle, close the cap.
The bottle may not be stored depending on its size or shape.
WARNING
Do not place anything other than a bottle in ...
Other materials:
ON / OFF Indication Parameter Error
DTC 01-E2 ON / OFF Indication Parameter Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
01-E2
The command for ON/OFF control from the master
device has a problem.
Radio receiver
INSPECTION PROCEDURE
HINT:
After the inspection is ...
Erasing the entire HomeLink® memory (all three programs)
Press and hold down the 2 outside
buttons for 10 seconds until
the indicator light flashes.
If you sell your vehicle, be sure to
erase the programs stored in the
HomeLink® memory.
Before programming
Install a new battery in the transmitter.
The battery side of the transmitter must ...
Installation
1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
(a) Install the drive shaft to the axle carrier.
NOTICE:
Be careful not to damage the boot and ABS
speed sensor rotor to the drive shaft and oil seal
of the axle hub bearing.
(b) Align the matchmarks and connect the drive shaft to
the side gear shaf ...
