Toyota Sienna Service Manual: Curtain shield airbag assembly

Disposal

HINT: When scrapping a vehicle equipped with the SRS or disposing of the front passenger airbag assembly, be sure to deploy the airbag first in accordance with the procedure described below. If an ...

On-vehicle inspection

1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the curtain shield airbag assembly installed on the vehic ...

Other materials:

Short to GND in Curtain Shield Squib RH Circuit
DTC B1162/81 Short to GND in Curtain Shield Squib RH Circuit DESCRIPTION The curtain shield squib RH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly RH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1162/81 is ...

Tire Pressure Warning Reset Switch Circuit
DESCRIPTION The ECU enters the initialization mode and performs initialization automatically, when the tire pressure warning ECU receives the signal from the tire pressure warning reset switch. If the ECU receives the signal, the tire pressure warning light blinks 3 times (1 second on, 1 seco ...

Disassembly
HINT: Overhaul the RH side by the same procedures as these of the LH side. 1. REMOVE REAR WHEEL 2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH HINT: Do not disconnect the flexible hose from the brake caliper. 3. REMOVE REAR DISC (a) Release the parking brake, and remove the rear disc. H ...