Toyota Sienna Service Manual: Customize parameters

Toyota Sienna Service Manual / Engine hood / door / Power back door system / Customize parameters

HINT: The following items can be customized.

NOTICE:

After confirming whether the items requested by the customer are applicable or not for customization, perform the customize operation.
Be sure to record the current settings before customizing.
When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization.

Power Back Door ECU

Power Back Door ECU

*1 Wireless (transmitter switch) operation of the power slide door is disabled.

*2 When this item is set to ON: When the back door is fully open, manually moving the back door approximately 12 cm within 0.5 sec. in the direction that the back door closes activates the power back door system to automatically close.

*3 When this item is set to ON: When the back door is fully closed, pulling the outside activates the power back door system to automatically open after the back door is unlatched.

Operation check

NOTICE: Inspection should be started after conforming that the items listed in the "CUSTOMIZE PARAMETER" for the power back door system have defaulted to the initial settings 1. CHECK ...

Initialization

1. RESET When the back door lock is replaced: The power back door ECU cannot receive a switch signal from the lock. This may cause the power back door system to enter fail-safe mode and DTC ...

Other materials:

Removal
1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY 4. REMOVE FRONT DOOR TRIM BOARD SUBASSEMBLY LH 5. REMOVE SEAT MEMORY SWITCH Disengage the 4 claws and remove the seat memor ...

Installation
1. INSTALL FRONT AXLE ASSEMBLY LH (a) Install the 2 bolts, nuts and front axle assembly LH with the 2 bolts and nuts to the shock absorber assembly front LH. Torque: 230 N*m (2,350 kgf*cm, 170 ft.*lbf) NOTICE: Only when reusing the bolts and nuts, apply the small amount of engine oil ...

Air Mix Damper Position Sensor Circuit (Passenger Side)
DESCRIPTION This sensor detects the position of the air mix control servo motor (air mix damper) and sends the appropriate signals to the A/C amplifier. The position sensor is built in the air mix control servo motor. The position sensor's resistance changes as the air mix control servo m ...