Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Customizing vehicle features

Changing using the audio system screen

  1. Press the “SETUP� button.
  2. Select “Vehicle� on the “Setup� screen.
  1. Press the “APPS� button.
  2. Select “Setup� on the “Apps� screen and select “Vehicle�.

Various setting can be changed. Refer to the list of settings that can be changed for details.

Changing using the multi-information display

  1. Press the “DISP� switch to display the “SETTINGS� screen while the vehicle is stopped, and then press and hold the “DISP� switch to display the customize mode screen.
  2. Press the “DISP� switch and select the item, and then press and hold the “DISP� switch.
  3. Press the “DISP� switch and select the desired setting, and then press and hold the “DISP� switch.

To exit the customize mode, press the “DISP� switch to select the “EXIT�, and then press and hold the “DISP� switch.

  1. Use the meter control switches to select while the vehicle is
    stopped, and then press the center button to display the customize mode screen.
  2. Select the desired item, and then press the center button.
  3. Select the desired setting, and then press the center button.

To go back to the previous screen or exit the customize mode, press .


Customization
Customizable features Your vehicle includes a variety of electronic features that can be personalized to your preferences. The settings of these features can be changed using the multi-information ...

Customizable features
Settings that can be changed using the audio system screen Settings that can be changed using the multi-information display Settings that can be changed by your Toyota dealer Definition of s ...

Other materials:

Installation
1. INSTALL VANE PUMP ASSEMBLY (a) Temporarily install the bolt to the vane pump assembly. (b) Install the vane pump assembly. (c) Temporarily install the bolt (B). (d) Using SST, tighten the 2 bolts. SST 09249-63010 Torque:Without SST 43 N*m (439 kgf*cm, 32 ft.*lbf) With SST 29 ...

Door control switch
INSPECTION 1. INSPECT DOOR CONTROL SWITCH ASSEMBLY  Measure the resistance according to the value(s) in the table below. Standard resistance HINT: If the result is not as specified, replace the switch. ...

Installation
1. INSTALL OCCUPANT CLASSIFICATION ECU  Check that the ignition switch is off.  Check that the negative battery (-) terminal is disconnected. CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation.   ...

© 2011-2026 Copyright www.tsienna.net