Toyota RAV4 manuals

Toyota Sienna Service Manual: Data list / active test

1. DATA LIST

HINT: Using the intelligent tester to read the DATA LIST allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Warm up the engine.

(b) Turn the ignition switch off.

(c) Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.

(d) Turn the ignition switch to the ON position.

(e) Turn on the tester.

(f) Select the item "DIAGNOSIS / ENHANCED OBD II / DATA LIST".

(g) According to the display on the tester, read the "DATA LIST".

Data list / active test

Data list / active test

2. ACTIVE TEST

HINT: Using the intelligent tester to perform ACTIVE TEST allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing ACTIVE TEST early in troubleshooting is one way to save diagnostic time.

DATA LIST information can be displayed while performing ACTIVE TEST

(a) Warm up the engine.

(b) Turn the ignition switch off.

(c) Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.

(d) Turn the ignition switch to the ON position.

(e) Push the "ON" button of the intelligent tester.

(f) Select the item "DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST".

(g) According to the display on tester, perform the "ACTIVE TEST".

ACTIVE TEST

*: "SOLENOID (SLT)" in the ACTIVE TEST is performed to check the line pressure changes by connecting the SST to the automatic transaxle, which is used in the HYDRAULIC TEST (See page AX-14) as well.

HINT: The pressure values in ACTIVE TEST and HYDRAULIC TEST are different from each other.

Fail-safe chart
1. FAIL-SAFE This function minimizes the loss of the ECT functions when any malfunction occurs in a sensor or solenoid. (a) ATF (Automatic Transmission Fluid) temperature sensor: When the ATF t ...

Diagnostic trouble code chart
If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the page given. HINT: *1: Comes on MIL (Malfunction Indicator Lamp) light up *2: "DT ...

Other materials:

DTC check / clear
1. DTC CHECK/CLEAR (USING INTELLIGENT TESTER:)  DTC check  Connect the intelligent tester to the DLC3. Turn the ignition switch to the ON position.  Read the DTCs on the tester screen.  DTC clear  Connect the intelligent tester to the DLC3. &n ...

Data list / active test
1. READ DATA LIST HINT: Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be disco ...

Front Fog Light Circuit
DESCRIPTION The Multiplex network body ECU controls FOG relay when signal is received from headlight dimmer switch assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER Connect the intelligent tester to DLC3. Turn the ignition switch ON and push t ...

В© 2011-2024 Copyright www.tsienna.net