Toyota RAV4 manuals

Toyota Sienna 2010-2026 Owners Manual: Deleting a Bluetooth® device

  1. Display the “Bluetooth* Setup� screen. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc.
  2. Select “Remove�.
  3. Select the desired device.
  4. A confirmation message will be displayed, select “Yes� to delete the device.
  5. Check that a confirmation screen is displayed when the operation is complete

When deleting a Bluetooth® phone

The contact data will be deleted at the same time.

How to register a Bluetooth® device
Display the “Bluetooth* Setup� screen. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc. Select “Add�. When this screen is displayed, search for the device name ...

Connecting a Bluetooth® device
Up to 5 Bluetooth® devices (Phones [HFP] and audio players [AVP]) can be registered. If more than 1 Bluetooth® device has been registered, select which device to connect to. Press the “SE ...

Other materials:

Terminals of ecu
Check tire pressure warning ecu HINT: Inspect the connectors from the back side while the connectors are connected. (a) Disconnect the tire pressure warning antenna and receiver connector. (b) Measure the voltage according to the value(s) in the table below. (c) Connect the tire pr ...

Problem symptoms table
RESULT LIST OF CHECK CAN BUS LINE Symptom Suspected Area All ECUs and sensors connected to the CAN communication system are not displayed on intelligent tester CAN Bus Line The result of "CAN BUS WIRE CHECK" is "Open in CAN Main Bus Lin ...

No Answer-Back (Hazard Warning Light and Wireless Door Lock Buzzer)
DESCRIPTION If there is no answer-back of the hazard light signal and the wireless door lock buzzer although the wireless control function is operating normally, there might be a malfunction in the hazard light signal and the wireless door lock buzzer signal which are output from the multiple ...

© 2011-2026 Copyright www.tsienna.net