Toyota RAV4 manuals

Toyota Sienna Service Manual: Diagnosis system

1. DESCRIPTION

 DESCRIPTION

(a) Release the parking brake pedal.

(b) Check the warning lights.

When ignition switch is turned ON, check that the ABS warning light and brake warning light come on for 3 seconds.

HINT:

Problem symptoms table
If there are no DTCs output but the problem still occurs, check the circuits for each problem symptom in the order given in the table below and proceed to the relevant troubleshooting page. NOTICE ...

Dtc check / clear
1. DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE): (a) DTC check (1) Using SST, connect terminals TC and CG of the DLC3. SST 09843-18040 (2) Turn the ignition switch to the ON position. (3) R ...

Other materials:

Diagnostic trouble code chart
HINT: If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC. For details of each code, turn to the page for the respective DTC Code. in the DTC chart. Inspect the fuse and relay before investigating the trouble areas as shown in the table below. ...

Initialization
Items to initialize The following items must be initialized for normal system operation after such cases as the battery being reconnected, or maintenance being performed on the vehicle. Item When to initialize Power sliding door (if equipped) After reconnecting o ...

Open in Occupant Classification ECU Battery Positive Line
DTC B1794 Open in Occupant Classification ECU Battery Positive Line DESCRIPTION This circuit consists of the occupant classification ECU and the power source circuit (battery, fuse, wire harness). DTC B1794 is recorded when a malfunction is detected in the occupant classification ECU or t ...

В© 2011-2024 Copyright www.tsienna.net