Toyota Sienna Service Manual: Diagnosis system

Toyota Sienna Service Manual / Door lock / Key reminder warning system / Diagnosis system

1. CHECK DLC3

CHECK DLC3

The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.

CHECK DLC3

NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors.

If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.

CHECK DLC3

Connect the cable of the intelligent tester to the DLC3, turn the ignition switch to the ON position and attempt to use the intelligent tester. If the screen displays a communication error message, a problem exists in the vehicle side of the tester side.

HINT:

If communication is normal when the tool is connected to another vehicle, inspect the DLC3 on the original vehicle.
If communication is still impossible when the tool is connected to another vehicle, the problem is probably in the tool itself. Consult the Service Department listed in the tool's instruction manual.

Terminals of ECU

1. CHECK DRIVER SIDE J/B ASSEMBLY (MULTIPLEX NETWORK BODY ECU) Disconnect the B6, 1C, 1K and 1L J/B connectors. Measure the voltage and resistance according to the value(s) in th ...

Data list / active test

1. READ DATA LIST HINT: Using the intelligent tester's DATA LIST allows switch, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshootin ...

Other materials:

Inspection
1. INSPECT NO. 1 VALVE ROCKER ARM SUBASSEMBLY (a) Turn the roller by hand to check that it turns smoothly. HINT: If the roller does not turn smoothly, replace the valve rocker arm sub-assembly. 2. INSPECT VALVE LASH ADJUSTER ASSEMBLY NOTICE: Keep the lash adjuster free of dirt ...

Mass or Volume Air Flow Circuit Range / Performance Problem
DESCRIPTION Refer to DTC P0100 (See page ES-116). MONITOR DESCRIPTION The MAF meter is a sensor that measures the amount of air flowing through the throttle valve. The ECM uses this information to determine the fuel injection time and to provide an appropriate air-fuel ratio. Insi ...

Engine compartment
Items Check points Battery Check connections Brake fluid Is the brake fluid at the correct level? Engine coolant Is the engine coolant at the correct level? Engine oil Is the engine oil at the correct level? Exhaust system ...