Toyota Sienna Service Manual: Diagnosis system
1. CHECK DLC3
- The vehicle uses ISO 15765-4 communication
protocol.
The terminal arrangement of the DLC3 complies with SAE 1962 and matched the ISO 15765-4 format.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
Terminals of ECU
1. FOLD SEAT CONTROL ECU LH
Disconnect the fold seat control ECU connectors.
Measure the voltage and resistance of the wire
harness side connectors.
If the result is not as specifie ...
On-vehicle inspection
1. CHECK POWER REAR NO. 2 SEAT with STOWING FUNCTION
Check the basic functions.
Operate the fold seat switch and power rear
No.2 seat switch and check to make sure each
seat ...
Other materials:
Brake
GENERAL MAINTENANCE
1. INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Check the entire circumference and length of the brake
hoses using a mirror as required in a well-lighted area.
Turn the front wheels fully right or left before checking
the front brakes.
(a) Check all the brake lines and h ...
Short to GND in Rear Curtain Shield Squib RH
Circuit
DTC B1632/81 Short to GND in Rear Curtain Shield Squib RH
Circuit
DESCRIPTION
The rear curtain shield squib RH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly RH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC ...
Under hood
GENERAL MAINTENANCE
1. GENERAL NOTES
Maintenance requirements very depending on the
country.
Check the maintenance schedule in the owner's
manual supplement.
Following the maintenance schedule is mandatory.
Determine the appropriate time to service the vehicle
using either miles dri ...
