1. CHECK DLC3
NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors.
If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connector.
HINT:
Operation check
1. INPUT SIGNAL CHECK
Connect the intelligent tester to the DLC3.
Check the cruise control main switch using the
DATA LIST function in the intelligent tester (ONOFF,
CANCEL, - (COAST)/SET, + (ACCEL)/RES
(RESUME), and MODE).
2. INSPECT MODE SWITCH
Turn the ...
High mounted stop light assembly
COMPONENTS
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER (w/ Rear Spoiler)
2. REMOVE REAR SPOILER COVER (w/ Rear Spoiler)
3. REMOVE CENTER STOP LIGHT ASSEMBLY
w/o Rear spoiler:
Disconnect the connector and remove the 2
screws and the center stop light assembly.
...
Front door lock
INSPECTION
1. INSPECT FRONT DOOR W/ MOTOR LOCK ASSEMBLY LH
Apply battery voltage to the door lock and check
operation of the motor.
OK
HINT:
If the result is not as specified, replace the door lock
assembly.
Measure the resistance according to the value(s) in
the table ...