1. BUS CHECK
HINT: The ECUs and sensors that are properly connected to the CAN communication system can be displayed using the intelligent tester via the CAN VIM.
HINT: Properly connected ECUs or sensors that are not displayed on the screen indicate that a communication stop is occuring in the system, sensor, or ECU which is not displayed.
2. CHECK FOR INSTALLED SYSTEMS (ECUS AND SENSORS) THAT USE CAN COMMUNICATION
HINT:
3. DTC TABLE BY ECU
HINT:
Perform troubleshooting according to "CHECK CAN BUS LINE" (See page CA-35).
HINT: DTC communication uses the CAN communication system.
HINT:
HINT: The network gateway ECU is connected to the CAN communication system, but CAN communication DTCs are not output.
4. DTCS COMBINATION TABLE
HINT: *1: with Dynamic laser cruise control
Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DTC B2223 Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DESCRIPTION
A pulse sensor is built into slide door RH for jam and foreign
object detection and for slide door position
detection. The jam and foreign object detection feature of the pulse sensor
monitors the ...
Back Door ECU Communication Stop
DTC B1287 Back Door ECU Communication Stop
DESCRIPTION
DTC B1287 is output when communication between the power back door ECU and
the multiplex network
gateway ECU stops for more than 10 seconds.
DTC No.
DTC Detection Condition
Trouble Area
B1287
Back d ...
Diagnostic trouble code chart
COMMUNICATION DIAGNOSIS:
DVD PLAYER:
CD PLAYER
IN-DASH CD CHANGER
...