Toyota RAV4 manuals

Toyota Sienna Service Manual: Differential

Installation
1. INSTALL REAR DRIVE SHAFT ASSEMBLY LH (a) Install the drive shaft to the axle carrier. NOTICE: Be careful not to damage the boot and ABS speed sensor rotor to the drive shaft and oil seal o ...

Differential system
PRECAUTION NOTICE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected. 1. Before disassembly, clean the outside of the rear ...

Other materials:

Checking monitor status
The purpose of the monitor result (mode 06) is to allow access to the results for on-board diagnostic monitoring tests of specific components/systems that are not continuously monitored. Examples are catalyst, evaporative emission (EVAP) and thermostat. The monitor result allows the OBD II sc ...

Reassembly
1. INSTALL COOLER DRYER (a) Using needle nose pliers, install the cooler dryer. (b) Install a new O-ring on the cap. (c) Sufficiently apply compressor oil to the fitting surfaces of the O-ring and the cap. Compressor oil: ND-OIL 8 or equivalent (d) Using a hexagon wrench 14 mm ( ...

Installation
1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY (a) Connect the connector. (b) Install the tire pressure warning receiver assembly with the bolt. Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 2. INSTALL ROOF HEADLINING ASSEMBLY HINT: Refer to the instructions for INSTALLATION of the ROOF ...

В© 2011-2026 Copyright www.tsienna.net