1. REMOVE CYLINDER BOOT
(a) Using a screwdriver, remove the set ring and cylinder boot.
2. REMOVE REAR DISC BRAKE PISTON
(a) Place a shop rug, between the rear disc brake piston and the disc brake cylinder.
(b) Use compressed air to remove the rear disc brake piston from the disc brake cylinder.
CAUTION: Do not place your fingers in front of the piston when using compressed air. |
NOTICE: Do not spatter the brake fluid.
3. REMOVE PISTON SEAL
(a) Using a screwdriver, remove the piston seal from the disc brake cylinder assembly rear LH.
NOTICE: Do not damage the inner cylinder and cylinder groove.
4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP
5. REMOVE REAR DISC BRAKE BLEEDER PLUG
(a) Remove the rear disc brake bleeder plug from the disc brake cylinder assembly rear LH.
6. REMOVE REAR DISC
(a) Make matchmarks on the rear disc and the axle hub.
(b) Remove the rear disc.
Receiver Error
DTC C2176/76 Receiver Error
DESCRIPTION
The signals are transmitted to the tire pressure warning antenna and receiver
on the body as radio waves
and then sent to the tire pressure warning ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTICE:
When replacing the tire pressure warning EC ...
Installation
1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY
(a) Install the parking brake control pedal assembly with
a bolt and the 2 nuts.
Torque: 39 N*m (398 kgf*cm, 29 ft.*lbf)
(b) Connect the parking brake switch connector.
(c) Connect the instrument panel junction block
assembly w/ wiring ha ...
Rear Airbag Sensor LH Circuit Malfunction
DTC B1155/39 Rear Airbag Sensor LH Circuit Malfunction
DESCRIPTION
The rear airbag sensor LH circuit consists of the center airbag sensor
assembly and rear airbag sensor
LH.
If the center airbag sensor assembly receives signals from the rear airbag
sensor LH, it judges whether or
not the ...