Toyota Sienna Service Manual: Disassembly
1. REMOVE AIR REFINER ELEMENT
(a) Release the 2 claw fittings and remove the air filter sub-assembly.
(b) Remove the air refiner element from the air filter cover plate.
2. REMOVE COOLING UNIT DAMPER SERVO SUBASSEMBLY
(a) Remove the 3 screws and the cooling unit damper servo sub-assembly.
3. REMOVE BLOWER RESISTOR (for Manual Air Conditioning System)
(a) Remove the 2 screws and the blower resistor.
4. REMOVE BLOWER MOTOR CONTROL (for Automatic Air Conditioning System)
(a) Remove the 2 screws and the blower motor control.
5. REMOVE BLOWER WITH FAN MOTOR SUBASSEMBLY
(a) Remove the 3 screws and the blower w/ fan motor sub-assembly.
Removal
1. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY WITH PASSENGER AIRBAG ASSEMBLY
HINT:
Refer to the instructions for removal of the instrument
panel sub-assembly w/ passenger airbag assembly (See
page IP-5) ...
Reassembly
1. INSTALL BLOWER WITH FAN MOTOR SUBASSEMBLY
2. INSTALL BLOWER MOTOR CONTROL (for
Automatic Air Conditioning System)
3. INSTALL BLOWER RESISTOR (for Manual Air
Conditioning System)
4. INSTALL COO ...
Other materials:
Monitor drive pattern
1. MONITOR DRIVE PATTERN FOR ECT TEST
(a) Perform this drive pattern as one method to
simulate the detection conditions of the ECT
malfunctions. (The DTCs may not be detected due
the actual driving conditions. And some codes may
not be detected through this drive pattern.)
HINT:
Preparation f ...
Low Battery Positive Voltage
DTC C1241/41 Low Battery Positive Voltage
DESCRIPTION
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT ECU-IG FUSE
(a) Remove the ECU-IG fuse from the driver side J/B.
(b) Check continuity of the ECU-IG fuse.
Standard resistance
2 CHECK BATTERY
(a) Check the positive battery volt ...
Gauges and meters
The displayed content may differ depending on the type of meter.
Vehicles with monochrome display
Vehicles with color display
Tachometer
Displays the engine speed in revolutions per minute
Multi-information display
Presents the driver with a variety of driving-related d ...
