1. REMOVE FRONT BUMPER ENERGY ABSORBER
2. REMOVE FRONT BUMPER REINFORCEMENT SUBASSEMBLY
3. REMOVE FRONT BUMPER SIDE SUPPORT LH
4. REMOVE FRONT BUMPER SIDE SUPPORT RH
HINT: Perform the same procedure as for the LH side.
5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (See page PM-19)
6. REMOVE NO. 1 ULTRASONIC SENSOR (LH side) (w/ Clearance Sonar System) (See page PM-19)
7. REMOVE NO. 1 ULTRASONIC SENSOR (RH side) (w/ Clearance Sonar System)
HINT: Perform the same procedure as for the LH side.
8. REMOVE RADIATOR GRILLE
9. REMOVE UPPER RADIATOR GRILLE
10. REMOVE FRONT BUMPER EMBLEM
11. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light)
12. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light)
HINT: Perform the same procedure as for the LH side.
13. REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light) (See page LI-82)
14. REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
HINT: Perform the same procedure as for the LH side.
15. REMOVE LOWER RADIATOR GRILLE
Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DTC B2223 Power Slide Door Pulse Sensor Malfunction on
Rear Right Door
DESCRIPTION
A pulse sensor is built into slide door RH for jam and foreign
object detection and for slide door position
detection. The jam and foreign object detection feature of the pulse sensor
monitors the ...
VSC Warning Light does not Come ON
DESCRIPTION
The skid control ECU is connected to the combination meter via CAN and
multiplex communications.
If the skid control ECU stores DTCs to shut down TRAC and VSC operation, the VSC
warning light comes
on in the combination meter.
WIRING DIAGRAM
Refer to VSC Warning Light Remains ...
DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
Checking DTCs.
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON.
Read DTCs by following the prompts on the
tester screen.
HINT:
Refer to the intelligent tester operator's manual
for furthe ...