Toyota RAV4 manuals

Toyota Sienna Service Manual: Display does not Dim when Light Control Switch is Turned ON

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / Display does not Dim when Light Control Switch is Turned ON

INSPECTION PROCEDURE

1 CHECK IMAGE QUALITY SETTING

 CHECK IMAGE QUALITY SETTING

  1. Enter the display adjustment screen by pressing the "DISPLAY" switch.
  2.  Turn the light control switch to the TAIL position.
  3.  Check if "DAY MODE" on the display adjustment is ON.

OK: "DAY MODE" is ON.

TURN "DAY MODE" SETTING OFF

2 CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)

CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)

  1. Enter the "Display Check" mode (Vehicle Signal Check).
  2.  Check that the display changes between ON and OFF according to the light control switch operation.

OK

OK

HINT: The display is updated once per second. It is normal for the display to lag behind the actual switch operation.

REPLACE RADIO AND NAVIGATION ASSEMBLY

Illumination for Panel Switch does not Come on with Tail Switch ON
INSPECTION PROCEDURE 1 CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE) Enter the "Display Check" mode (Vehicle Signal Check Mode).  Check that the display changes between ON and OF ...

Panel Switches do not Function
INSPECTION PROCEDURE 1 CHECK PANEL SWITCH Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found 2 CHECK PANEL SWITCH (DISPLAY CHECK MODE ...

Other materials:

Park / Neutral Position Switch Circuit
DESCRIPTION The fold seat control ECU receives signals from the Park/Neutral position switch and controls the seat stowing and return operations. If the shift lever is in any position other than P the seat cannot be operated. If the ignition switch is in ACC or IG the seat cannot be operate ...

Diagnostic trouble code chart
HINT: The parameters listed in the chart may not confirm exactly to those read during the DTC check due to the type of instrument or other factors. If a trouble code is displayed during the DTC check in the check mode, check the circuit for the code listed in the table below. For details of ...

DRL Relay Circuit
DESCRIPTION The Multiplex network body ECU controls the DRL No.2 relay WIRING DIAGRAM INSPECTION PROCEDURE 1 PERFORM ACTIVE TEST BY INTELLIGENT TESTER Connect the intelligent tester to DLC3.  Turn the ignition switch ON and push the intelligent tester main switch ON.  Sel ...

В© 2011-2024 Copyright www.tsienna.net