Toyota Sienna Service Manual: Distance Control Switch Circuit
DESCRIPTION
The distance control switch sets the vehicle-to-vehicle distance mode. The distance control switch is installed in the steering pad switch. The vehicle-to-vehicle distance set value can be changed by operating the steering pad switch (distance control switch) while the dynamic laser cruise control system is in operation.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT STEERING PAD SWITCH ASSEMBLY
- Remove the steering pad switch assembly
- Measure the resistance according to the value(s) in the table below.
Standard resistance
HINT: When a malfunction is detected in the distance control switch, replace the steering pad switch assembly.
2 INSPECT SPIRAL CABLE
NOTICE: The spiral cable is an important part of the SRS airbag system. Incorrect removal or installation of the spiral cable may cause airbag deployment. Be sure to read the page shown in the brackets.
HINT:
- Removal (34)
- Installation
- Remove the spiral cable.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
HINT: The spiral cable makes a maximum of approximately 5 rotations.
3 CHECK HARNESS AND CONNECTOR (DISTANCE CONTROL ECU - SPIRAL CABLE)
- Disconnect the D2 distance control ECU connector.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
4 CHECK HARNESS AND CONNECTOR (SPIRAL CABLE - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard resistance
5 INSPECT DISTANCE CONTROL ECU
- Remove the distance control ECU with the connector.
- Turn the ignition switch to the ON position.
- Measure the voltage according to the value(s) in the table below.
Standard voltage
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Distance Control ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the distance control ECU. The distance
control ECU determines
information about the vehicle in front based on data from the laser sensor, and
t ...
Laser Sensor Power Source Circuit
DESCRIPTION
This circuit provides power to the laser sensor. The laser sensor emits radio
waves towards an object in
front and measures the distance and direction of the object by receiving the
...
Other materials:
Brake fluid
Checking fluid level
The brake fluid level should be
between the “MAX” and “MIN”
lines on the tank.
“MAX” line
“MIN” line
Adding fluid
Lift the cover off.
Make sure to check the fluid type and prepare the necessary item.
Brake fluid can absorb moisture from t ...
Mute Signal Circuit between Radio and Navigation Assembly and
Television Display Assembly
DESCRIPTION
The radio and navigation assembly controls the volume according to the MUTE
signal from the television
display assembly.
The MUTE signal is sent to reduce noise and a popping sound generated when
switching the mode, etc.
If there is an open in the circuit, noise can be heard ...
Reassembly
1. INSTALL REAR SEAT STAY SUB-ASSEMBLY
Install the seat stay sub-assembly with the nut.
Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
2. INSTALL NO. 2 SEAT CUSHION SPRING ASSEMBLY
RH
3. INSTALL LOCUS CABLE RH
Install the locus cable RH with the nut.
Torque: 5.5 N*m (56 kgf*cm, ...
