Toyota Sienna Service Manual: Door control switch
INSPECTION
1. INSPECT DOOR CONTROL SWITCH ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
Standard resistance
HINT: If the result is not as specified, replace the switch.
Door control transmitter
INSPECTION
1. INSPECT DOOR CONTROL TRANSMITTER
Inspect operation of the transmitter.
Remove the battery (lithium battery) from the transmitter.
Install a new or norm ...
Unlock warning switch
INSPECTION
1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY
Remove the unlock warning switch assembly .
Measure the resistance according to the value(s) in
the table below.
Standa ...
Other materials:
Washer Signal Circuit
DESCRIPTION
The distance control ECU detects washer operation. The cruise control will be
cancelled by the distance
control ECU if the windshield wipers operate in the HI or LO mode. By detecting
washer operation, the
distance control ECU allows the cruise control to continue even when the
...
Air Inlet Damper Control Servo Motor Circuit
DESCRIPTION
The air inlet control servo motor is controlled by the A/C amplifier and
moved to the desired position.
The air inlet control servo motor switches the air inlet mode by rotating
(normal, reverse) with electrical
power from the A/C amplifier. This controls intake air and changes ...
Differential system
PRECAUTION
NOTICE:
When disconnecting the negative (-) battery terminal,
initialize the following systems after the terminal is
reconnected.
1. Before disassembly, clean the outside of the rear
differential assembly and remove any sand or mud to
prevent it from entering the inside of the as ...
