Toyota Sienna Service Manual: Drive shaft

Installation

1. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY (a) Align the matchmarks on the propeller shaft assembly rear flange and differential companion flange, and connect the shaft with the 4 bol ...

Drive shaft system

PRECAUTION 1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (a) When removing and installing the front drive shaft assembly RH in a 4WD vehicle, be sure to first drain all the t ...

Other materials:

For manual air conditioning system
ON-VEHICLE INSPECTION 1. INSPECT AIR INLET CONTROL SERVO MOTOR (a) Remove the air inlet control servo motor. (b) Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, then check that the lever turns to "RECIRCULATION" side smoothly. ...

Pressure Sensor Circuit
DTC B1423/23 Pressure Sensor Circuit DESCRIPTION This DTC is output when refrigerant pressure on the high pressure side is extremely low (0.19 MPa (2.0 kgf/cm2, 28 psi) or less) or extremely high (3.14 MPa (32.0 kgf/cm2, 455 psi) or more). The pressure sensor, which is installed on the pipe ...

Installation
1. INSTALL NO. 2 REAR SEAT OUTER BELT ASSEMBLY NOTICE: Do not disassemble the retractor.  Check the degree of tilt when the No. 2 rear seat outer belt assembly begins to lock the ELR.  Check that the belt does not lock within 15 of tilt in all directions but that the be ...