Toyota RAV4 manuals

Toyota Sienna Service Manual: Dtc check / clear

1. DTC CHECK (USING SST CHECK WIRE)

DTC CHECK (USING SST CHECK WIRE)

(a) Check DTCs.

(1) Turn the ignition switch off.

(2) Using SST, connect terminals TC and CG of DLC3.

SST 09843-18040

(3) Turn the ignition switch to the ON position.

(4) Read and record any DTCs from the tire pressure warning light on the combination meter.

Refer to the illustration as examples of a normal system code and codes 13 and 33.

HINT:

(5) Refer to the Diagnostic Trouble Code Chart (See page TW-37) for DTC information.

(6) After completing the check, turn the ignition switch off and remove SST from DLC3.

SST 09843-18040

2. DTC CHECK (USING INTELLIGENT TESTER)

(a) Check DTCs.

(1) Make sure that the ignition switch is off.

(2) Connect the intelligent tester to the DLC3.

(3) Turn the ignition switch to the ON position.

(4) Read the DTCs following the prompts on the tester screen.

HINT: Refer to the intelligent tester operator's manual for further details.

(b) Clear the DTCs.

HINT: After repairing the malfunctions, clear the DTCs.

(1) Make sure that the ignition switch is off.

(2) Connect the intelligent tester to DLC3.

(3) Turn the ignition switch to the ON position.

(4) Clear the DTCs following the prompts on the tester screen.

HINT: Refer to the intelligent tester operator's manual for further details.

Diagnosis system
1. CHECK BATTERY VOLTAGE Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge the battery before proceeding. 2. CHECK DLC3 (a) The ECU uses the ISO 15765-4 for communication pr ...

Data list / active test
1. DATA LIST HINT: Using the intelligent tester to read the DATA LIST allows the values or states of switches, sensor, actuators and other items to be read without removing any parts. This non-in ...

Other materials:

Casual speech recognization
Due to natural language speech recognition technology, this system enables recognition of a command when spoken naturally. However, the system cannot recognize every variation of each command. In some situations, it is possible to omit the command for the procedure and directly state the desir ...

Inspection
1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH  Release the seat belt (Buckle switch is ON).  Check the resistance between the terminals. Standard If the result is not as specified, replace the inner belt assembly.  Inspect the buckle switch.  Fasten ...

Oxygen Sensor Heater Control Circuit Low/ Oxygen Sensor Heater Control Circuit High/ Oxygen Sensor Heater Circuit Malfunction
DTC P0037 Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) DTC P0038 Oxygen Sensor Heater Control Circuit High (Bank 1 Sensor 2) DTC P0057 Oxygen Sensor Heater Control Circuit Low (Bank 2 Sensor 2) DTC P0058 Oxygen Sensor Heater Control Circuit High (Bank 2 Sensor 2) DTC P0141 Oxyg ...

В© 2011-2024 Copyright www.tsienna.net