Toyota RAV4 manuals

Toyota Sienna Service Manual: DTC check / clear

1. USING INTELLIGENT TESTER

  1.  Hook up the intelligent tester to the DLC3.
  2.  Monitor the ECU data by following the prompts on the tester screen.

HINT: intelligent tester has "Snapshot" function which records the monitored data. Please refer to the intelligent tester operator's manual for further details.

2. DTC CLEAR

  1.  DTC and freeze frame data can be erased by operating the intelligent tester.
Terminals of ECU
1. Instrument Panel Junction Block Assembly ...

Data list / active test
1. DATA LIST HINT: By the DATA LIST displayed by the intelligent tester, you can read the value of the switch, sensor, actuator and so on without removing any part. Reading the DATA LIST as the f ...

Other materials:

Rear axle hub bolt
COMPONENTS Replacement HINT: Replace the RH side using the same procedures as for the LH side. 1. REMOVE REAR WHEEL 2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH (a) Separate rear disc brake caliper assembly LH for 2WD and disk rear brake type (See page AH-16). 3. SEPARATE REAR D ...

Open or Short Circuit in ABS Solenoid Relay Circuit
DESCRIPTION The ABS solenoid relay is built in the brake actuator assembly. This relay supplies power to each ABS solenoid. If the initial check is OK, after the ignition switch is turned to the ON position, the relay goes on. WIRING DIAGRAM Refer to DTCs C0226/21, C0236/22, C0246/23 ...

Replacing a flat tire
Chock the tires. Slightly loosen the wheel nuts (one turn). Turn the tire jack portion A by hand until the notch of the jack is in contact with the jack point. The jack point guides are located on the side of rocker moulding. They indicate the jack point po ...

В© 2011-2024 Copyright www.tsienna.net