Toyota Sienna Service Manual: DTC check / clear
1. CHECK DTC (USING INTELLIGENT TESTER)
- Checking DTCs.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON.
- Read DTCs by following the prompts on the tester screen.
HINT: Refer to the intelligent tester operator's manual for further details.
2. CLEAR DTC (USING INTELLIGENT TESTER)
- Clearing the DTCs from memory.
- Connect the intelligent tester to the DLC3.
- Turn the ignition switch ON.
- Erase the DTCs following the prompts on the tester screen.
HINT: Refer to the intelligent tester operator's manual for further details.
Diagnosis system
1. CHECK DLC3
The vehicle's ECU uses ISO 15765-4 for
communication protocol. The terminal arrangement
of the DLC3 complies with SAE J1962 and matches
the ISO 15765-4 format.
NOT ...
Data list / active test
1. DATA LIST
HINT:
Using the DATA LIST displayed on the intelligent tester,
you can read the value of the switch, sensor, actuator,
etc. without parts removal. Reading the DATA LIST as
the first ...
Other materials:
Rear Air Outlet Damper Control Servo Motor Circuit
DESCRIPTION
This circuit turns the servo motor and changes each damper position by
receiving the signals from the A/
C amplifier.
The rear air outlet damper servo motor switches the air outlet mode by rotating
(normal, reverse) with
electrical power from the A/C amplifier.
WIRING DIAGRAM
...
Short to B+ in Rear Curtain Shield Squib LH
Circuit
DTC B1638/86 Short to B+ in Rear Curtain Shield Squib LH
Circuit
DESCRIPTION
The rear curtain shield squib LH circuit consists of the center airbag sensor
assembly and the curtain
shield airbag assembly LH.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B ...
Setting the vehicle speed (vehicle-to-vehicle distance control
mode)
Press the “ON-OFF” button to
activate the cruise control.
Dynamic radar cruise control indicator
will be displayed.
Press the button again to deactivate
the cruise control.
Accelerate or decelerate the
vehicle to the desired speed,
and push the lever down to set
...
