Toyota Sienna Service Manual: Dtc clear
(A) when using the obd ii scan tool or intelligent tester: clearing the dtcs.
(1) Connect the intelligent tester together with the CAN VIM (controller area network vehicle interface module) to the DLC3.
(2) Turn the ignition switch to the ON position and turn the OBD II scan tool or the intelligent tester main switch on.
(3) When you use intelligent tester: Select the item "DIAGNOSIS/ENHANCED OBD II/DTC INFO/ CLEAR CODES [YES] button".
HINT: When operating the OBD II scan tool (complying with SAE J1978) or intelligent tester to erase the codes, the DTCs and freeze frame data will be erased. (See the OBD II scan tool's instruction book for operating instructions.) (b) When not using the OBD II scan tool or intelligent tester: Clearing the DTCs.
(1) Disconnect the battery cable or remove the EFI and ETCS fuses from the engine room J/B for 60 seconds or more. However, if you disconnect the battery cable, perform do the "INITIALIZE" procedure.
Check mode procedure
HINT:
Check mode has a higher sensitivity to malfunctions and can
detect malfunction that normal mode cannot detect. Check
mode can also detect all the malfunctions that normal mode
can detect. In ...
Fail-safe chart
1. FAIL-SAFE
This function minimizes the loss of the ECT functions
when any malfunction occurs in a sensor or solenoid.
(a) ATF (Automatic Transmission Fluid) temperature
sensor:
When the ATF t ...
Other materials:
Data list / active test
HINT:
By accessing the DATA LIST displayed by the intelligent
tester, you can perform such functions as reading the values
of switches and sensors without removing any parts. Reading
the DATA LIST as the first step in troubleshooting is one
method to shorten labor time.
1. DATA LIST FOR OCCUPA ...
Distance Control ECU Malfunction
DTC P1617 Distance Control ECU Malfunction
DESCRIPTION
In the dynamic laser cruise control system, the ECM and the distance control
ECU communicate with one
another to control the system based on some designation information. If the
designation information of the
ECM and distance control ECU ...
Installation
1. INSTALL OUTSIDE MOULDING
Using a heat light, heat the mounting surface of the
vehicle body between 40 to 60 C (104 to 140 F).
NOTICE:
Do not heat the body excessively.
Remove the tape from the vehicle body.
Wipe off the stains with cleaner.
Clean the outside moulding (if reusing t ...
