Toyota Sienna Service Manual: DVD-ROM Abnormal

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / DVD-ROM Abnormal

DVD-ROM Abnormal

DESCRIPTION

DTC No.	DTC Detection Condition	Trouble Area
44-43	DVD-ROM operation is abnormal.	DVD Television display assembly

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 CHECK IF A PROPER DVD IS INSERTED

Make sure that the DVD is a video DVD or a CD with an MP3 file, and that it is not deformed, flawed, stained, burred, or otherwise defective.

OK: Normal DVD or CD

HINT:

Translucent or uniquely-shaped DVDs or CDs cannot be played.
For details on playable DVDs or CDs, refer to the Owner's Manual.

2 CHANGE DISC

Replace the disc with another and recheck.

Replace the disc with another normal one.
Clear the DTCs.
Recheck for DTCs and check if the same trouble occurs again.

OK: Malfunction disappears.

END

Wrong Disc/ Disc cannot be Read

DTC 44-41 Wrong Disc DTC 44-42 Disc cannot be Read DESCRIPTION DTC No. DTC Detection Condition Trouble Area 44-41 An unsuitable disc is inserted DVD ...

DVD Error/ Excess Current/ Tray Insertion / Ejection Error

DTC 44-44 DVD Error DTC 44-48 Excess Current DTC 44-50 Tray Insertion / Ejection Error DESCRIPTION DTC No. DTC Detection Condition Trouble Area 44-44 Operation ...

Other materials:

Scratched / Reversed Disc
DTC 62-46 Scratched / Reversed Disc DTC 63-46 Scratched / Reversed Disc DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 62-46 Scratches or dirt is found on CD surface or CD is set upside down. CD Radio receiver ...

Transmission Range Sensor Circuit Malfunction (PRNDL Input)
DESCRIPTION The park/neutral position switch detects the shift lever position and sends signals to the ECM. HINT: After confirming DTC P0705, use the intelligent tester to confirm the PNP switch signal in the ALL menu (to reach the ALL menu: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ...

How to proceed with troubleshooting
1 VEHICLE BROUGHT TO WORKSHOP 2 INSPECT BATTERY VOLTAGE Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge or replace the battery before proceeding. 3 BASIC INSPECTION Turn the ignition switch ON. Check whether or not the radio receiver turns on. Result 4 CHE ...