Toyota RAV4 manuals

Toyota Sienna Service Manual: Dynamic laser cruise control system

Toyota Sienna Service Manual / Cruise control / Dynamic laser cruise control system

TC and CG Terminal Circuit
DESCRIPTION Connecting terminals TC and CG of the DLC3 causes the system to enter the self-diagnostic mode. If a malfunction is present, DTCs will be output. HINT: When a particular warning li ...

Precaution
Keep in mind the following points when inspecting the dynamic laser cruise control system.  As there is a limitation on the vehicle-to-vehicle distance controlling capability, do not overl ...

Other materials:

Suspension
SERVICE DATA A: Ground clearance of front wheel center B: Ground clearance of lower suspension arm No. 2 set bolt center C: Ground clearance of rear axle carrier bush set bolt center D: Ground clearance of rear wheel center TORQUE SPECIFICATIONS TIRE AND WHEEL SERVICE DATA T ...

Distance Control ECU Power Source Circuit
DESCRIPTION This circuit provides power to operate the distance control ECU. The distance control ECU determines information about the vehicle in front based on data from the laser sensor, and then decides how much acceleration and/or deceleration is needed to maintain the set distance. The ...

Room temperature sensor
On-vehicle inspection 1. INSPECT A/C ROOM TEMPERATURE SENSOR (a) Remove the A/C room temperature sensor. (b) Measure the resistance according to the value(s) in the table below. Standard resistance NOTICE: Even slightly touching the sensor may change the resistance value. Be sure ...

В© 2011-2026 Copyright www.tsienna.net