Toyota Sienna Service Manual: ECM

Installation

1. INSTALL THROTTLE BODY  Install a new throttle body gasket to the intake air surge tank. Install the throttle body with the 4 bolts. Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) ...

Removal

1. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  Push the right side wall and then push the left wall to release the stoppers. Pull the glove compartment door sub-assembly rearwar ...

Other materials:

Removal
1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY 2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY 3. DRAIN ENGINE COOLANT 4. REMOVE V-BANK COVER SUB-ASSEMBLY 5. REMOVE NO. 2 AIR CLEANER INLET 6. REMOVE NO. 1 AIR CLEANER INLET 7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY Disconnect the 3 vacuum hoses. ...

Installation
1. INSTALL COMPRESSOR AND MAGNETIC CLUTCH (a) Using a "TORX" socket wrench (E8), install the compressor and magnetic clutch with the 2 stud bolts. Torque: 10 N*m (102 kgf*cm, 7.4 ft.*lbf) HINT: Tighten the stud bolts in the order shown in the illustration. (b) Install the c ...

Operating instructions
Turning the end of the lever turns on the lights as follows: The illustration is intended as an example. U.S.A. Canada The headlights, side marker, parking lights, daytime running lights (if equipped) and so on turn on and off automatically (when the engine switch is ...