Toyota Sienna Service Manual: Engine hood courtesy switch
Inspection
1. INSPECT ENGINE HOOD COURTESY SWITCH
- Measure the resistance according to the value(s) in the table below.
Standard resistance
If the result is not as specified, replace the hood lock assembly.
ECU Power Source Circuit
DESCRIPTION
This circuit provides power to operate the theft deterrent (warning) ECU.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FUSE (ECU-B)
Remove the ECU-B fuse from the engine room ...
Security horn assembly
INSPECTION
1. INSPECT SECURITY HORN ASSEMBLY
Check operation of the horn.
Standard
If the result is not a ...
Other materials:
Brake fluid
Checking fluid level
The brake fluid level should be
between the “MAX” and “MIN”
lines on the tank.
“MAX” line
“MIN” line
Adding fluid
Lift the cover off.
Make sure to check the fluid type and prepare the necessary item.
Brake fluid can absorb moisture from t ...
Sound Signal Circuit between Radio and Navigation Assembly and
Stereo Component Amplifier
DESCRIPTION
The radio and navigation assembly sends a sound signal to the stereo
component amplifier through this
circuit.
The sound signal that has been sent is amplified by the stereo component
amplifier, and then is sent to
the speakers.
If there is an open or short in the circuit, s ...
Changing the vehicle-to-vehicle distance
Pressing the button changes the
vehicle-to-vehicle distance as follows:
Long
Medium
Short
The vehicle-to-vehicle distance is
set automatically to long mode
when the engine switch is turned to
IGNITION ON mode.
If a vehicle is running ahead of
you, the preceding vehicle mark
w ...
