Toyota RAV4 manuals

Toyota Sienna Service Manual: Engine immobiliser

Toyota Sienna Service Manual / Engine immobiliser

Security horn assembly
INSPECTION 1. INSPECT SECURITY HORN ASSEMBLY  Check operation of the horn. Standard If the result is not a ...

Engine immobiliser system
PARTS LOCATION SYSTEM DESCRIPTION The engine immobiliser system has been designed to prevent the vehicle from being stolen. This system uses a transponder key ECU that stores the key code of t ...

Other materials:

Open or Short Circuit in ABS Solenoid Relay Circuit
DESCRIPTION The ABS solenoid relay is built in the brake actuator assembly. This relay supplies power to each ABS solenoid. If the initial check is OK, after the ignition switch is turned to the ON position, the relay goes on. WIRING DIAGRAM Refer to DTCs C0226/21, C0236/22, C0246/23 ...

Installation
1. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY (a) Install the power steering gear assembly with the 2 bolts and nuts. Torque: 70 N*m (714 kgf*cm, 52 ft.*lbf) 2. CONNECT PRESSURE FEED TUBE ASSEMBLY (a) Connect the pressure feed tube assembly to the power steering gear asse ...

Precaution
1. INITIALIZATION NOTICE: Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See page AX-16). Perform REGISTRATION (VIN registration) when replacing the ECM (See page ES-15). HINT: Initializatio ...

В© 2011-2026 Copyright www.tsienna.net