Toyota RAV4 manuals

Toyota Sienna Service Manual: Engine oil pressure switch

Toyota Sienna Service Manual / Meter / Engine oil pressure switch

ON-VEHICLE INSPECTION

1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY

  1.  Disconnect the connector from the oil pressure switch assembly.
  2.  With the switch still installed, measure the resistance between the terminal of the engine oil pressure switch and engine ground.

Standard Resistance:

Engine stopped: Below 1 Ω
Engine idling: 10 kΩ or higher

HINT: If the value is not as specified, replace the engine oil pressure switch.

Fuel sender gauge assembly
INSPECTION 1. INSPECT FUEL SENDER GAUGE ASSEMBLY  Disconnect the connector from the fuel sender gauge.  Check that the float moves smoothly between F and E.  Measure th ...

Audio / visual
...

Other materials:

On-vehicle inspection
1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)  Perform a diagnostic system check.  Even if the airbag was not deployed, check if there is any dama ...

How to proceed with troubleshooting
HINT:  Use this procedure to troubleshoot the engine immobiliser system.  The intelligent tester should be used in steps 4, 5 and 7. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK 3 CRANK ENGINE FOR MORE THAN 10 SECONDS 4 CHECK FOR DTC C ...

Rear power window switch
INSPECTION 1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY REAR  Check the resistance between the switch terminals when the switch is operated. Standard If the result is not as specified, replace the switch assembly. ...

В© 2011-2026 Copyright www.tsienna.net