Toyota Sienna Service Manual: Extension housing oil seal

Installation

1. INSTALL TRANSFER CASE OIL SEAL (a) Using SST, install anew transfer case oil seal to the transfer case at the position shown in the illustration. SST 09387-00010, 09950-70010 (09951-07150) ...

Removal

1. REMOVE TRANSFER CASE NO.1 PLUG (See page TF-8) 2. REMOVE TRANSFER DRAIN PLUG (a) Remove the transfer drain plug, drain gasket and bleed transfer oil. 3. REMOVE EXHAUST PIPE ASSEMBLY HINT: (S ...

Other materials:

Clock setting
Display the “General Settings” screen. Operations up to this point can also be performed by select the clock display at the top of most screens. Select the items to be set. Manual clock setting Set minutes to 00 The 24-hour time format can be to on/off. Select � ...

Removal
1. DISCONNECT BATTERY NEGATIVE TERMINAL 2. REMOVE FRONT DOOR SCUFF PLATE LH 3. REMOVE COWL SIDE TRIM BOARD LH 4. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER LH (See page IP-6) 5. REMOVE REAR DOOR SCUFF PLATE RH 6. REMOVE REAR DOOR SCUFF PLATE LH 7. REMOVE FRONT SEAT ASSEMBLY LH HI ...

Camshaft Position "B" - Timing Over
HINT: If DTC P0014, P0015, P0024 or P0025 is present, check the VVT (Variable Valve Timing) system. DESCRIPTION Refer to DTC P0013 (See page ES-87). MONITOR DESCRIPTION DTC P0014 and P0024 The ECM compares current valve timing with target valve timing, while the engine is running a ...