HINT: If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.
Vehicle Condition |
Auto Cancel Condition |
Re-operation Condition |
CRUISE main indicator light blinks |
|
Turn cruise control main switch on again |
CRUISE main indicator light blinks |
|
Turn ignition switch off then on again |
Cruise control is cancelled (The indicator light remains on) | At the following conditions, the stored vehicle
speed is maintained.
|
Push cruise control main switch to + (ACCEL)/RES (RESUME) |
|
Push cruise control main switch to - (COAST)/ SET |
Removal
HINT:
On the RH side, use the same procedures as on the LH side.
1. REMOVE BACK DOOR STAY SUB-ASSEMBLY LH
Remove the 2 bolts and disconnect the stay from
the body panel.
Using the screwdriver, disengage the clips and
remove the stay from the door panel.
Remove the bolt from door pa ...
Front floor footrest
COMPONENTS
Removal
1. REMOVE FRONT FLOOR FOOTREST
Using a screwdriver, disengage the 2 clips and
remove the footrest.
HINT:
Tape the screwdriver tip before use.
Disengage the clips and then remove the 2 clips
from the footrest.
INSTALLATION
1. INSTALL FRONT FLOOR FOOTREST ...
Mute Signal Circuit between Radio Receiver and Stereo Component
Amplifier
DESCRIPTION
This circuit sends a signal to the stereo component amplifier to mute noise.
Because of that, the noise
produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when
changing the sound source.
If there is a short i ...