1. AUTO CANCEL FUNCTION (FAIL-SAFE FUNCTION):
HINT: If a system malfunction occurs, the applicable DTCs will appear on the multi-information display. In some cases, a DTC will be set due to weather or vehicle operating conditions, this does not indicate a system malfunction.
If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:
The cruise control operation will be suspended until the main switch is turned on again.
The auto cancel function deletes the stored vehicle speed and cancels the cruise control operation when:
If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:
The cruise control operation will be suspended until the ignition switch is turned off then on again.
The auto cancel function maintains the stored vehicle speed and cancels the cruise control operation when:
If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:
The cruise control operation will be suspended until either the canceling condition is resolved or the main switch is turned on again. When the canceling condition is resolved, it will be possible to resume the vehicle speed set prior to cancellation by pushing the cruise control main switch to + (ACCEL)/RES (RESUME).
The auto cancel function maintains the stored vehicle speed and cancels the cruise control operation when the laser sensor has dirt on it.
If the auto cancel function operates, the warning sound "pong" is emitted once. In addition, the following warnings will continue until the cruise control main switch is turned off:
The cruise control operation will be suspended until either the canceling condition is resolved or the main switch is turned on again. When the canceling condition is resolved, it will be possible to resume the vehicle speed set prior to cancellation by pushing the cruise control main switch to + (ACCEL)/RES (RESUME).
The auto cancel function maintains the stored vehicle speed and cancels the cruise control operation when:
If the auto cancel function operates, the CRUISE main indicator light remains on. The cruise control operation will be suspended until the canceling condition is resolved. When the canceling condition is resolved, it will be possible to resume the vehicle speed set prior to cancellation by pushing the cruise control main switch to + (ACCEL)/RES (RESUME).
The auto cancel function deletes the stored vehicle speed and cancels the cruise control operation when the vehicle speed drops 16 km/h (10 mph) below the stored vehicle speed.
If the auto cancel function operates, the CRUISE main indicator light remains on. The cruise control operation will be suspended until the canceling condition is resolved. When the canceling condition is resolved, it will be possible to set the vehicle speed by pushing the cruise control main switch to - (COAST)/SET.
Radio and Navigation Assembly Power Source Circuit
DESCRIPTION
This is the power source circuit to operate the radio and navigation
assembly.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT RADIO AND NAVIGATION ASSEMBLY
Disconnect the radio and navigation assembly connector
R15.
Measure the resistance according to the value ...
Removal
1. PRECAUTION
HINT:
See page RS-1
2. DISCONNECT BATTERY NEGATIVE TERMINAL
Wait for 90 seconds after disconnecting the battery
terminal to prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEERING WHEEL COVER LOWER NO.2
(See page RS-424)
5. REMOVE STEERING WH ...
Sound Signal Circuit between Radio and Navigation Assembly and
Television Display Assembly
DESCRIPTION
The television display assembly sends an RSE sound signal to the radio and
navigation assembly through
this circuit. The sound signal that has been sent is amplified by the stereo
component amplifier, and then
is sent to the speakers.
If there is an open or short in the circuit ...