Toyota RAV4 manuals

Toyota Sienna Service Manual: Fog light assembly

Toyota Sienna Service Manual / Lighting / Fog light assembly

Daytime running light resister
On-vehicle inspection 1. DRL RESISTOR  Check that there is resistance between the terminals as shown in the chart. Resistance ...

Components
REMOVAL 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT BUMPER ASSEMBLY 3. REMOVE FOG LIGHT ASSEMBLY  Disengage the 2 claws  Disengage the 2 pins and rem ...

Other materials:

Open in ABS Motor Relay Circuit
DESCRIPTION The ABS motor relay supplies power to the ABS pump motor. While the ABS is activated, the ECU turns the motor relay on and operates the ABS pump motor. If the voltage supplied to the motor relay (+BM) is below the DTCs detection threshold due to low voltage from the battery ...

On-vehicle inspection
1. INSPECT FOR FUEL PUMP OPERATION AND FUEL LEAK (a) Check fuel pump operation. (1) Connect the intelligent tester to the DLC3. (2) Turn the engine switch on (IG) and push the intelligent tester main switch on. NOTICE: Do not start the engine. (3) Select the following menu it ...

Light Control Switch Circuit
DESCRIPTION This circuit detects the state of the headlight dimmer switch. WIRING DIAGRAM INSPECTION PROCEDURE 1 READ VALUE OF INTELLIGENT TESTER Connect the intelligent tester to DLC3.  Turn the ignition switch ON and push the intelligent tester main switch ON.  Select t ...

В© 2011-2026 Copyright www.tsienna.net