Toyota RAV4 manuals

Toyota Sienna Service Manual: Folding Motor Circuit

DESCRIPTION

The fold seat control ECU receives a switch operation signal from the fold seat switch and activates the folding motor. At this time, the Hall IC (seat cushion position sensor) detects the actuation signal. The fold seat control ECU uses signals from the Hall IC (seat cushion position sensor) to detect if an object if an object is caught or if any other abnormal condition has occurred.

WIRING DIAGRAM

WIRING DIAGRAM

INSPECTION PROCEDURE

1 INSPECT FOLD SEAT CONTROL ECU

INSPECT FOLD SEAT CONTROL ECU

  1. Remove the fold seat control ECU.
  2.  Measure the voltage according to the value(s) in the table below.

Standard voltage: LH side

Standard voltage

RH side

Standard voltage

2 CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - FOLDING MOTOR)

CHECK HARNESS AND CONNECTOR

  1. Disconnect the connector from the fold seat control ECU.
  2.  Disconnect the connector from the fold seat motor.
  3. Measure the resistance according to the value(s) in the table below.

Standard resistance: LH side

Standard resistance

RH side

Standard resistance

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

Fold Seat Switch Circuit
DESCRIPTION When the fold seat switch is operated, a switch operation signal is sent to the fold seat control ECU. The ECU receives switch operation signals from each switch and activates the fold ...

Reclining Motor Circuit
DESCRIPTION The fold seat control ECU receives a switch operation signal from the power rear no. 2 seat switch and the fold seat switch, and activates the reclining motor. At this time, the Hall ...

Other materials:

Hazard warning switch
INSPECTION 1. HAZARD WARNING SIGNAL SWITCH ASSEMBLY  Check that there is resistance between the terminals at each switch position as shown in the chart. Resistance Inspect illumination operation.  Connect the positive (+) lead from the battery to the termina ...

Evaporative Emission System Switching Valve Control Circuit High
DTC SUMMARY DESCRIPTION The circuit description can be found in the EVAP (Evaporative Emission) System (See page ES-404). INSPECTION PROCEDURE Refer to the EVAP System (See page ES-404). MONITOR DESCRIPTION 5 hours*1 after the ignition switch is turned off, the electric vacuum pump ...

Open in Rear Curtain Shield Squib LH Circuit
DTC B1636/88 Open in Rear Curtain Shield Squib LH Circuit DESCRIPTION The rear curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1636/88 ...

В© 2011-2024 Copyright www.tsienna.net