Toyota Sienna Service Manual: For manual air conditioning system
ON-VEHICLE INSPECTION
1. INSPECT BLOWER RESISTOR (for Manual Air Conditioning System)
(a) Measure resistance between terminals, as shown in
the table.
If resistance is not as specified, replace the blower resistor.
For rear air conditioning system)
ON-VEHICLE INSPECTION
1. INSPECT COOLING UNIT MOTOR SUB-ASSEMBLY WITH FAN
(a) Connect the positive (+) lead from the battery to
terminal 1 and negative (-) to terminal 2, then check
that the m ...
Other materials:
Disassembly
1. REMOVE RETURN TUBE NO.2
(a) Using SST, remove the return tube No. 2.
SST 09023-12701
2. REMOVE STEERING LEFT TURN PRESSURE TUBE
(a) Using SST, remove the left turn pressure tube.
SST 09023-38201
(b) Remove the 2 O-rings from the left turn pressure
tube.
3. REMOVE STEERING RIGH ...
System description
1. DESCRIPTION OF OCCUPANT CLASSIFICATION SYSTEM
GENERAL DESCRIPTION.
In the occupant classification system, the
occupant classification ECU calculates the
weight of the occupant based on a signal from
the occupant classification sensors. This system
recognizes the occu ...
Register transmitter id (using intelligent tester)
(a) Connect the intelligent tester to DLC3 (Procedure
"A").
(b) Turn the ignition switch to the ON position
(Procedure "B").
(c) Select the REGIST TIRE following the intelligent
tester screen (UTILITY - REGIST TIRE) (Procedure
"C").
(d) Input the IDs (ID1 t ...
