Toyota Sienna Service Manual: Front bumper

Exterior

...

Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 2. REMOVE FRONT BUMPER ASSEMBLY Remove the 4 screws and separate the fender liner from the front bumper assembly. Remove the 8 ...

Other materials:

Removal
HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE SLIDE DOOR Remove the rear door scuff plate (See page IR-7). Remove the back door scuff plate (See page ED- 214). Remove the quarter trim panel (See page IR-9). Remove the upper rail cushion from the rail. ...

Power Windows do not Operate at All
DESCRIPTION If all of the door windows do not operate, no power may be supplied to the power window master switch or the power window master switch itself may have a malfunction. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT FUSE (PWR, ECU-IG, AM1) Remove the fuses from the driver sid ...

Oxygen (A/F) Sensor Pumping Current Circuit
HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the Air-Fuel Ratio (A/F) sensor. Sensor 1 refers to the sensor mounted in front of the Three-Way Catalytic Converter (TWC) and located near the engine assembly. DESCRIPTION Refer to DTC P2195 (See page ES-355 ...