INSPECTION
1. INSPECT FRONT DOOR W/ MOTOR LOCK ASSEMBLY LH
OK
HINT: If the result is not as specified, replace the door lock assembly.
Standard resistance
HINT: If the result is not as specified, replace the door lock assembly.
Standard resistance
HINT: If the result is not as specified, replace the door lock assembly.
2. INSPECT FRONT DOOR LOCK W/ MOTOR ASSEMBLY RH
OK
HINT: If the result is not as specified, replace the door lock assembly.
Standard resistance
HINT: If the result is not as specified, replace the door lock assembly.
Standard resistance
HINT: If the result is not as specified, replace the door lock assembly
Open in Side Squib LH Circuit
DTC B0116/48 Open in Side Squib LH Circuit
DESCRIPTION
The side squib LH circuit consists of the center airbag sensor assembly and
the front seat side assembly
LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0116/48 is recorded when an open circuit is ...
Oxygen (A/F) Sensor Signal Stuck
HINT:
Although the DTC titles say oxygen sensor, these DTCs relate to the
Air-Fuel Ratio (A/F) sensor.
Sensor 1 refers to the sensor mounted in front of the Three-Way
Catalytic Converter (TWC) and
located near the engine assembly.
DESCRIPTION
The A/F sensor generates a voltage* ...
Inspection
1. Inspect generator clutch pulley
(a) Hold the center of the pulley, and confirm that the
outer ring turns counterclockwise and does not turn
clockwise.
If the result is not as specified, replace the clutch
pulley.
2. Remove generator drive end frame bearing
(a) Check that the bear ...